Configuration Files

The analysis problem input data is stored in the configuration file with extension .cfg. This is a specially formatted ASCII file, that can be viewed/edited in any ASCII text editor.

To start new analysis problem, create configuration file by clicking File, and then New in menu bar, or clicking icon New on the toolbar.

To continue with old analysis problem, load existing configuration file by clicking File, and then Open in menu bar, or clicking icon Open on the toolbar, and select the file to be opened. If you already have opened a configuration file, or have created new one, you will be asked to confirm the opening another configuration file.

To save the current analysis problem into the file, click File, and then Save in the menu bar. If the current analysis problem is new, you will be asked to specify the file name, or to select the existing file to be written. Otherwise the data will be saved into the same source file, that has been opened before.

You also can write the current analysis problem into another file, clicking File, and then Save As... in the menu bar.

The last 10 used files are shown at the bottom of menu File in menu bar.

The last used configuration file is automatically opened at program startup.

The program is shipped with a few example configuration files, located in directory examples.

Last modified: February 22, 2011